OM10C

General description of the OM10C

The high power combiner OM10C is designed for all short wave amateur bands from 1.8 to 29.7 MHz and maximum 10kW PEP output power.

Specification of OM10C:

Frequency coverage:	1.8 – 29.7 MHz continuous
Power rating:	10 kW PEP or continuous carrier into a matched load (VSWR below 1.2:1). Reduce the output at increased VSWR, linearly down to 5 kW at VSWR up to 2:1
Input impedance:	50 Ohm unbalanced, input UHF SO239 connector
SWR:	Less than 1,2 : 1 across band, input VSWR with 50 Ohm loads at the two splitter outputs: less than 1,2:1, 1,8-30MHz continuously (no tunings, no switching)
Output impedance:	50 Ohm unbalanced, output 7/16“ connector
Insertion loss:	very low insertions loss, less than 0,3 dB
Indications:	4.3" color touch screen display
Mechanical parameters:	165mm x 200mm x 350mm (width x height x depth)
Weight:	8.1 kg

LAN Connection

Power amplifier is interfaced to LAN via XPORT made by Lantronix (type XP1001000-05R). More info can be found at www.lantronix.com .

Default factory settings of XPORT are:

IP address: 192.168.1.233
Mask: 255.255.255.0
Gateway: 192.168.1.1

These are strictly default settings. You can modify any of these by going to XPORT web GUI via your web browser. We do not recommend changing any other parameters of the XPORT interface as loss of communication can be caused by doing so. There is no default user name or password. It is highly recommended to secure web interface with username and password.

For remote control and monitoring over LAN special software is needed. It is available free of charge; it can be downloaded from the following link: Remote control software version 1.02

NOTE: For the correct functioning of the software, it is necessary to have accessible LAN ports 9999 and 10001.